Super Bright Solar Motion Security Lights 3.2V 1200mAh SMD 2835

Super Bright Solar Powered Led Security Motion Detector Outdoor Light

​

• SOLAR POWERED

Carefully consider the installation for this solar garden wall lights. Try to avoid

the shadows by day and other sources of light at night that could trick the light

into thinking it is still daylight. Please remember the amount of light the solar

cell receives by day directly affects the runtime of the lamp at night. A poorly

positioned lamp will produce short runtimes at night.

• INSTALLATION

The design is all in one, no cable, just solar powered. Quick installation as bellow.

Simply cut a hole of 52 cm diameter ( 50 cm is the light tube) in the roofing and

insert into the light tube through, screwing back the black holding plate and clear

lens on the light tube in piece. Then the light will operate automatically at night

when movement detected and last for 45 seconds.

• OPERATION

Let the light charging under sunlight for at least 8hrs before first time using.

The light is fixed with light sensor and also PIR motion sensor.At darkness, the light

can be activated when people present or move in the detecting zone.

The light will last on as long as movement being detected and it will turn off in 45

seconds after the object leaving detecting zone.

• APPLICATION

This solar motion security light was originally designed for outdoor portable toilet

lighting, but after improvement it can also be used for the lighting of canopies,

such as bikies, sheds, plastic toilet, garages, carports, roof, etc.

• THE BATTERY REPLACEMENT

The battery is 3.2V 1200mAh Lifepo4 rechargeable battery which is easily replaceable.

If the battery begins to illuminate dimly or for short time and you know that it has

had sufficient sunlight on the panel, you should replace the battery in following way:

1. Take off the lens and holding plate,the pull off the lamp from the roofing.
2. Remove the 4 screws on the plate without damaging cables.
3. Disjoin the old battery and replace with a new battery.
4. Remount the unit back in piece.

5. WARNING – Polarity is important. Wrong polarity is dangerous and will destroy the unit.

Notes

• It is suggested to add a round soft material between light and holding plate

or use glass cement to glue all round of the light.So that water will not leak into

the house and even vapor cannot goes into the lamp.

• The light is not suggest to install where have intense air flow or over cold

or over heat place,such as air-condition, as these will make the PIR sensor wrong

function.

SMD 2835 Solar Motion Security Lights

1200mAh Solar Motion Security Lights

3.2V Super Bright Solar Security Light

Super Bright Solar Motion Security Lights 3.2V 1200mAh SMD 2835 Images